AquaCraft Mini Wildcat - Manual (Page 9)

9
1. It is important to remove and
lubricate the drive wires after a day
of running. Make sure the battery
pack is unplugged. To lubricate the
wire you will need:
• 1.5mm Allen wrench
• GrimRacer Cable Grease
• Paper Towels
2. Using a 1.5mm Allen wrench, loosen the set screws holding the drive
wires to the motor couplers. It is important to note that there are two
set screws holding each wire in position.
3. Slip the wires out the back of the
boat. Wipe off any grease and
water that might be on the wires.
4. Apply a small amount of GrimRacer Speed Grease to the wires and
slide them back into the boat. Be careful to align the wires to the
holes in the end of the motor couplers.
5. Leave about 1/16" [2mm] gap
between the front of the drive dogs
and the back of the shaft tubes.
6. Tighten the set screws to hold the wires in place. Do not over tighten
the set screws. It is also a good idea to tighten one screw lightly and
then the other. Go back and forth between the screws to keep even
tension on the drive wires.
MAINTENANCE