AquaCraft Air Force - Manual (Page 5)

backplate. If you see a gap, check to make sure that the prop
is installed correctly.
Installation of Batteries
❏
1. Remove the five hatch screws and lift the canopy
assembly from the deck.
❏
2. Remove the battery box. Do not cut the rubber bands.
❏
3. Install four new “AA” batteries into the battery box and
re-install the battery box into the boat. There is hook and loop
material provided with the model to make your battery box
extra secure. Make sure to plug the battery box connector
into the switch connector.
❏
4. Replace the canopy and secure it with the five hatch screws.
Transmitter Assembly
❏
1. Remove the transmitter antenna from the parts bag and
screw it into the top of the transmitter as shown. To ensure
that the antenna is attached, lightly pull on the base of the
antenna. If it slides out, it is not installed properly.
❏
2. Slide off the battery door on the bottom of the transmitter.
Install eight new “AA” batteries into the transmitter. Re-install
the battery door onto the bottom of the transmitter.
❏
3. Turn the transmitter on using the switch on the front. The
red LED light next to the on/off switch should light up. If the
LED does not light up, turn the transmitter off and check to
make sure that the batteries are installed properly. If you see a
flashing LED, the batteries are low and need to be replaced.
Check the Radio System:
• Pull the on/off switch located on the boat to the
“ON” position.
ANTENNA
STEERING RATE
(D/R)
STEERING
REVERSE
SWITCH
ON/OFF
SWITCH
POWER LED
(RED)
THROTTLE
REVERSE
SWITCH
STEERING
STEERING
TRIM
THROTTLE
TRIM
Install (8) new "AA" batteries
5