AquaCraft Air Force User Manual

Page 4

Note: If you have the prebuilt version, proceed to page 6.

Engine and Propeller Installation

❏

1. Looking down at the top (deck) of the hull, remove the

four large mounting screws with washers located toward the
rear of the hull (stern).

❏

2. Place the engine pod assembly onto the hull lining up the

four holes and making sure that the engine points forward,
toward the front of the hull (bow). The engine will appear to point
slightly to the starboard side (right). This is done deliberately to
counter the torque of the engine. Check the alignment by looking
down on the deck and engine from overhead.

❏

3. Install the four large mounting screws and washers.

Tighten them completely to make sure that the engine pod is
securely fastened to the hull.

❏

4. Locate the spinner assembly and propeller. Remove the

propeller (prop) nut and washer from the crankshaft of the engine.

❏

5. Separate the spinner assembly by removing the two

small self-tapping screws.

❏

6. Place the spinner backplate onto the crankshaft so that

it rests against the drive washer.

❏

7. Place the propeller onto the crankshaft so that the

blades rest against the alignment pegs of the backplate and
replace the prop washer.

❏

8. Replace the prop nut. IMPORTANT: Tighten the prop

nut firmly.

❏

9. Place the spinner cone over the prop so that the blades

of the prop fit into the notches of the cone. Replace the two
spinner assembly screws. The cone should sit flush against the

FINAL ASSEMBLY

FINISHING THE READY-TO-RUN AIR FORCE