Kofax capture, Kofax reporting, Specifying the wsa sender url – Kofax Capture User Manual
Page 7: Kofax reporting audits, Chapter 2

Kofax Product Support for Kofax Reporting
7
Chapter 2
Kofax Capture
As part of its comprehensive set of data, Kofax Reporting also includes all the information
traditionally available through Kofax Capture Report and Kofax Capture Advanced Reports.
The reporting platform does not replace the existing reporting capabilities, which remain in
place.
Kofax Reporting
The Kofax Reporting client software is installed with Kofax Capture 10.0.1 and later. During
installation, the
folder is specified as the location for reporting
configuration data.
Note To use Kofax Reporting, all workstations at a site must have installed the service pack.
All Kofax Reporting central site components, as well as the WSA (Web Service Architecture),
must be installed independently of Kofax Capture. In the case of Kofax Capture Network
Server, it is recommended that WSA Sender be installed at the Kofax Capture central site as
well as at each remote site to reduce possible network traffic across the WAN.
After installing the WSA, use the Reporting Client Configuration Utility to specify the WSA
URL. Also, in the WSA Configuration Utility (there are separate utilities for the receiver and
sender versions), set
as the location for the reporting configuration
data. This is done on the Advanced tab in the Client Config field.
Specifying the WSA Sender URL
Use the following procedure to set the URL:
1 At each Kofax Reporting sender machine, run
Kofax.Reporting.Configuration.Client.exe
, typically located at
\CaptureSS\Servlib\Bin
, although the path may vary.
2 Specify the WSA URL (the WSA Sender) in the form
http:// URL>: 3 Click “Test Connection” to verify the connection to the WSA Sender. Kofax Reporting Audits Kofax Reporting supports document, page, batch completion, operator and administration audits.
4 Click OK.