Panasonic SC-CH64M - Manual (Page 40)

Concerning compact discs
ÉS®
With this changer, you can only play compact
discs having this mark.
DIGITAL AUDIO
Handling precautions
To open the compact disc case, gently press the sides of the top and
pull up.
To remove the disc from the case, press the center holder and lift the
disc, holding by the edges.
To return the disc to the case, insert the disc with the label facing up
and press downward at the center.
Hold compact discs by the edges so as not to soil the surface with
fingerprints. Fingerprints, dirt and scratches can cause skipping and
distortion.
Do not use record cleaning sprays, benzine, thinner, static electricity
prevention liquids or any other solvent on a disc.
If the surface is soiled, wipe gently with a soft, damp (water only)
cloth.
Always move the cloth directly outward from the center of the disc,
not in a circular motion as with standard phonograph records.
If you are taking the disc from a cold to a warm environment,
moisture may form on the disc. Wipe this off with a soft, dry, tint-free
cloth before using the disc.
Do not write on the label side with a bail-point pen or other writing
instrument.
Storage precautions
Be sure to store discs in their cases to protect them from dust,
scratches, and warping.
Do not place or store discs in the following places;
1 ) Locations exposed to direct sunlight
2) Humid or dusty iocations
3) Locations directly exposed to a heat vent or heating appliance
4) in the glove compartment or on the rear deck of an automobile
Concerning cassette tapes
Selection of cassette tapes
Cassette tapes exceeding 100 minutes:
These tapes are handy for their long playback and recording time but
be careful about repeatedly stopping and starting, rewinding and fast
forwarding these tapes in short intervals as they are thin, tend to
stretch and may become entangled in the deck mechanism.
Endless-tapes:
Failure to operate these tapes correctly may cause the tape to wind
around the revolving parts.
For this unit, it is recommended to use the tape which is appropriate
to the auto reverse mechanism.
Tape slack
Tape slack may cause the tape to break.
Erasure prevention
Remove the tab(s).
To re-record on a protected cassette
Cover the slot with adhesive tape.
Do not cover the detection holes on high position and metal position
tapes.
Tape storage * •
Tapes can be damaged if stored in places such as those described
below.
•Where the temperature is high (35“C or higher) or where the humid­
ity is high (80% or higher)
•Where there is a strong magnetic field (near a speaker, on top of a
TV, etc.). Recording may become erased.
• In direct sunlight
40