Panasonic SC-CH64M - Manual (Page 10)

Memory presetting
•If broadcast frequencies are preset in the memory, you can easily
tune in any of these frequencies from the system or remote control
unit.
• Up to 12 stations can each be set in the FM, MW and LW (For
Australia and New Zealand: FM and AM) bands with the automatic
or manual memory presetting.
Automatic memory presetting
This example in the figure shows how to preset stations in the FM
band.
BAND
%
Press TUNER BAND to select
“FM”, “MW” or “LW”.
For Australia and Nev/Zealand;
Note that for Australia and New Zea­
land, there are two bands of *'FM” and
“AM" instead of “FM", “MW” and
“LW".
The power will come on automatically,
even if the stereo is on standby.
Press TUNING MODE to select
“MANUAL”.
Each time you press the button,
“MANUAL” and “PRESET’ will appear al­
ternately,
Press V or A until the display
'✓ TUNiHG/iiME ADJUST ^ sHows the frequency from
which you want to begin auto­
matic memory presetting.
Holding the button down will scroll the
frequency. Repeatedly tapping on it will
change the frequency one step with
every touch.
While scrolling, if the radio picks up a
station, it will automatically tune it in (auto
tuning).
Press and hold MEMORY/SET.
Release the button when the frequency
display begins to change.
The system will automatically memorize
the received broadcast frequencies in se­
quence.
10
The moment the frequency is memorized:
The station and channel will be displayed for about 1 second.
Channel
m fj i Ditar*'^
-'uBUo"-
Station
When auto memorization is compiete:
The last station to be memorized will be left on the display.
To confirm the preset stations:
1. Press TUNING MODE to select “PRESET".
2. Press V or A,
1209
Auto memory presetting does not work when radio waves from the
broadcasting station are too strong or too weak.
In such case, carry out presetting manually. (See below.)
Manual memory presetting
(After step 1-2 on the left of this page)
1. Press V or A to select the desired frequency, and press
MEMORY/SET. (“MEMO" flashes.)
2. Press V or A to select the preset channel, and then press
MEMORY/SET during “MEMO" flashes.
"MEMO” indicator goes off.
Memory retention:
The contents of the memory will continue to be stored for approxi­
mately 2 weeks, even if the power supply cord is disconnected.