Belt Drives CS-34A - Manual

CS-34A Compensator Installation Instructions
Read all installation instructions first! Verify primary chain sprocket alignment using supplied washers
/ spacers before final installation. Refer to OEM Service Manual for removal and installation of stock
primary drive components. Note* CS-34A is fully assembled with minimal amount of Anti-seize from
the factory and must be disassembled completely before following these instructions.
1. Safely support and secure motorcycle.
2. Disconnect the battery as per service manual.
3. Drain primary fluid into pan.
4. Remove outer primary cover and gasket.
5. Remove existing sprocket or compensator.
Primary chain and clutch basket if needed. Visibly
mark primary chain to ensure same rotaion on
sprockets.
6. To assemble CS-34A apply a thin coat of
Anti-seize to the sprocket carrier threads as
needed. Apply a thin coat of assembly lube to the
larger Nylatron washer and install washer over
threads of sprocket carrier, to the face of the flange.
7. Apply a thin coat of Anti-seize to the threads of
the CS-34A sprocket. Note the recessed surfaces of
the sprocket, the larger recess faces larger Nylatron
washer and carrier body.