Belt Drives CS-25A - Manual

Belt Drives Ltd. CS-24A-1 & CS-25A-1 INSTALLATION INSTRUCTIONS
Refer to OEM service manual for primary cover, and compensator removal and installation
“test fit first and achieve proper primary chain alignment before final assembly”
3. Remove existing sprocket or compensator &
spacer. Refer to Harley manual for removal
instructions for your year and model bike..
2. Drain primary fluid, and remove
outer primary cover and gasket.
4. Evenly apply a small amount of Anti-Sieze
to all of the threads of the compensator
sprocket carrier body.
5. Evenly apply a small amount of
Anti-Sieze to all of the threads of the
compensator sprocket.
6. Lightly grease and install (1) of the Nylatron
washers into one of the recessed pockets of
the compensator sprocket. “Either side is OK”
7. Thread carrier body into sprocket, make
sure nylatron washer seats fully into the
recessed pocket.
8. Flip the carrier body and sprocket, so the
face of the carrier body is in the palm of
your hand, lightly grease the 2nd nylatron
washer and place it in the recessed pocket
of sprocket assembly.
1. Support and secure motorcycle,
then disconnect the battery as per
your service manual.
9. Install the rear steel spacer, “steel spacer
goes on top off nylatron washer”. When
assembled steel spacer should sit just below
the height of carrier body.