Belt Drives Supplement for 3” Belt Drive - Manual

BOLT IN INSERT INSTALLATION SUPPLEMENT FOR 3” OPEN BELT DRIVE
BEFORE INSTALLING THE INSERT, BE SURE THAT YOU DO NOT REQUIRE AN OFFSET FRONT PULLEY FOR A WIDE
TIRE OFFSET TRANSMISSION APPLICATION. THIS PULLEY CAN BE USED FOR AN OFFSET APPLICATION WITH THE
PROPER INSERT. OFFSET INSERT KITS ARE AVAILABLE FROM ¼” to 2”
'SPOUPulley pictured with stock inseSt*/45%
1. Place insert into pulley as shown.
2. Using a drift
, punch or press, install the (3) ¼” roll pins into the (3) non-threaded smaller holes on the insert from
the
back side of pulley.
4. Install front pulley assembly in accordance with installation instructions supplied with belt drive.
Pictured below are BDL's insert kits which can be used with this pulley.
IN-250 1/4"
IN-500 1/2"
IN-750 3/4"
IN-1000 1"
IN-1250 1-1/4"
IN-1500 1-1/2"
IN-1750 1-3/4"
IN-2000 2"
1
3. From the inside, install and Loctite® bolts and washers so that they are secure.