Losi LOSB9606 - Manual (Page 18)

Ni
D.
Ni MH S en sit ivity
D. Pe ak D ef au lt
L iPo BALANCE
2.0A 11.1V(3S)
R : 3 S E R S : 3 S E R
C O N F I R M ( E N T E R )
- -
+ +
Start
Enter
Batt type
Stop
‘>3 seconds’
Start
Enter
Ni MH S en sit ivity
D. Pe ak D ef au lt
Charged
capacity
Number
of
cells
Charging
time
Charging
current
Battery
voltage
Charging a lithium battery
Charging a lithium battery
Charging a lithium battery in balance mode
17
The left side of the first line shows the type of battery you have
selected. The value on the left side of the second line is the current
you have selected. After setting the current and voltage, press the
‘START/ENTER’ key for more than three seconds to start the process
(charge current: 0.1-5.0A, voltage: 3.7-22.2V)
This function allows voltage balancing of the cells of lithium-polymer batteries while charging. In
the balance mode, the battery balance leads must be connected to the appropriate balance port
at the right side of the charger. The battery power leads must also be connected to the output
leads of the charger.
This charge mode utilizes the built-in processor to monitor the voltage of individual cells and
control input current fed into each cell to normalize the voltage.
This screen shows the real-time status while charging. Press the
‘BATT TYPE/STOP’ key once to stop charging.
This screen shows the number of cells in the battery. “R” depicts the
number of cell detected by the charger and “S” depicts the number
of cells selected by you on the previous screen. If both numbers are
identical, you can start charging by pressing the ‘START/ENTER’ key.
If not, press the ‘BATT TYPE/STOP’ key to go back to the previous
screen. Carefully check the number of cells of the battery pack
before proceeding.
L i 3 s 1 . 2 A 1 2 . 5 9 V
B A L 0 2 2 : 4 3 0 0 6 8 2