Modifying your chassis (continued…) – Karcepts KSM01 User Manual
Page 6
Left side of chassis tunnel
2. MODIFYING YOUR CHASSIS (continued…)
5. Temporarily affix the template by threading the M8 cap screws into the welded
nuts of the chassis (or place M8 cap screws in newly drilled holes of an
automatic transmission chassis). You will have to slide the template
underneath of the carpet in some areas.
6. The paper template is a bit flexible, so as best you can, keep the long straight
side of the template parallel with the left side of the chassis tunnel and mark the
centers of the two upper holes. Before marking the cut-out for your chassis, we
will confirm the hole locations in the future steps.
Dashed line
indicates side
of
template
Once
parallelism
is
confirmed,
mark
the
centers
of
the
holes
for
drilling.