Craftsman 137.212370 User Manual
Craftsman Gardening equipment
Table of contents
Document Outline
- 3. REMOVE ADJUSTING KEYS AND WRENCHES.
- 5. DO NOT USE IN DANGEROUS ENVIRONMENTS.
- 15. DISCONNECT TOOLS FROM POWER SOURCE
- 20, NEVER LEAVE THE TOOL RUNNING UNATTENDED. TURN THE POWER OFF. Do not
- ELECTRIGAL REQUiREMENTS
- ACCESSORIES AND ATTAGH!\/IENTS
- FORASSE
- SAW BLADE WRENCH (FIG. B-1)
- CUTTING HEAD (FIG. C)
- Locking
- INSTALLING THE DUST BAG (FIG. D)
- Fig.D
- Fig. E
- To avoid Injury:
- Fig.F
- MOUNTING THE MITER SAW (FIG. G, G-1)
- Fig. G
- Do not use a blade larger than 10 in. in diameter.
- Removing Blade (Fig. H, I and J)
- Fig. H
- Fig. J
- Installing Blade (Fig. H, I, J)
- THE LASER GUIDE (FIG. K)
- Fig.K
- To avoid injuty from an accidental start, make sure
- 90° (0°) Bevel adjustment (Fig. L)
- 90° Bevel Pointer Adjustment (Fig. M)
- 45“ Bevel Adjustment (Fig. N)
- Fig. O
- FIg.P
- MITER SCALE INDICATOR ADJUSTMENT (FIG. O)
- ADJUSTING FENCE SQUARENESS (FIG. P)
- ADJUSTING CUTTING DEPTH (FIG. Q)
- OPERATION
- KEEP YOUR WORK AREA CLEAN
- To avoid bums or other fire damage, never use the
- PLAN YOUR WORK
- INSPECT YOUR WORKPIECE
- DO NOT OVERREACH
- Never cut freehand:
- USE EXTRA CAUTION WITH LARGE OR ODD
- To avoid injury, follow all applicable safety
- BASIC SAW OPERATIONS
- TO TURN SAW ON (FIG. S)
- Finishing a cut:
- Fig. R
- To avoid injury, check and tighten the arbor bolt periodically.
- Fig.S
- To reduce the risk of injury, return carriage to the full rear position after each crosscut operation.
- BEFORE LEAVING THE SAW
- MITER CUT (FIG. U)
- Fig.V
- To avoid injury:
- To Slide Cut Wide Boards (Fig. Y)
- Fig.Y
- CUTTING BOWED MATERIAL (FIG. Z)
- Fig. BB
- Fig. CC
- Bevel/Miter Settings Fig. FF
- NOTE: The chart below references a compound cut for crown molding ONLY WHEN THE ANGLE
- MAINTENANCE
- TR0UBLESHCX3T1NG GUIDE