To avoid injury, To slide cut wide boards (fig. y), Fig.y – Craftsman 137.212370 User Manual

Page 20

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

NOTE; The saw comes with a 33.9° crown molding

stop.

33.9” BEVEL STOP FOR CROWN MOLDING (FIG. W)

1. Push the bevel detent stop pin (2) in toward the front

of the machine.

2, Loosen the bevel lock handle (1),
3. Rotate the cutting head until the bevel detent pin

stops the bevel angle at 33.9° on the bevel scale.

4, Tighten the bevel lock handle before making a cut.

Fig. W

SLIDE CUTTING WIDE BOARDS UP TO 12 in. WIDE
(FIG. Y)

COMPOUND CUT (FIG. X)
A compound cut is the combination of a miter and a

bevel cut simultaneously.
1, Loosen the bevel lock handle (1) and position the

cutting head at the desired bevel position. Lock the
bevel lock handle.

2. Loosen the miter handle (2). Press down the positive

stop locking lever (3) and position the table at the
desired angle. Release the positive stop locking lever
and lock the miter handle.

Fig.X

WARNiNG

To avoid injury:

® Never pull the cutting head assembly and spinning

blade toward you during the cut. The blade may try

to climb up on the top of the workpiece, causing the
cutting assembly and spinning blade to kick back,
forcefully. The cutting head a^embly should be
drawn back completely then pushed forward when
sawing,

« Let the blade reach full speed before cutting. This

will help reduce the risk of a thrown workpiece.

To Slide Cut Wide Boards (Fig. Y)

1. Unlock the carriage lock handle (1) and allow the

cutting head assembly to move freely,

2. Set both the desired bevel angle and/or the miter

angle and lock into position.

3. Use a hold down damp to secure the workpiece,
4, Grasp the switch handle (2) and pull the carriage (3)

forward until the center of the saw blade is over the
front of the workpiece (4).

5. Engage the trigger to turn the saw on.
6, When the saw reaches full speed, push the switch

handle down, slowly, cutting through the leading
edge of the workpiece.

7, Slowly move the switch handle toward the fence,

completing the cut,

8, Release the trigger and allow the blade to stop

spinning before allowing the cutting head to raise,

Fig.Y