Craftsman 917.270752 User Manual
Page 148
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLESHOOTING CHART
PROBLEM
CAUSE
CORRECTION
Will not start
• Out of fuel.
• Fill fuel tank.
* Engine not “CHOKED"
properly.
• See‘TO START ENGINE"
in Operation section.
• Engine flooded.
• Wait several minutes
before attempting to start.
• Bad spark plug.
• Replace spark plug.
• Dirty air filter.
• Clean/replace air filter.
• Dirty fuel filter.
• Replace fuel filter.
• Water in fuel.
• Drain fuel tank and
carburetor, refill tank with
fresh gasoline and replace
fuel filter.
• Loose or damaged wiring.
• Check all wiring.
• Carburetor out of adjustment. • See “To Adjust Carburetor"
in Senrice Adjustments
section.
• Engine valves out of
adjustment.
• Contact an
authorized service center/
department.
Hard to start
• Dirty air filter.
• Clean/replace air filter.
• Bad spark plug.
• Replace spark plug.
• Weak or dead battery.
• Recharge or replace
battery.
• Dirty fuel filter.
• Replace fuel filter.
• Stale or dirty fuel.
• Drain fuel tank and refill
with fresh gasoline.
• Loose or damaged wiring.
• Check all wiring.
• Carburetor out of adjustment. • See ‘To Adjust Carburetor”
in Service Adjustments
section.
• Engine valves out of
adjustment.
• Contact an authorized
service center/department.
Engine will not
turn over
• Clutch/brake pedal not
depressed.
• Depress clutch/brake
pedal.
• Attachment clutch is
engaged.
• Disengage attachment
clutch.
* Weak or dead battery.
• Recharge or replace
battery.
• Blown fuse.
• Replace fuse.
• Corroded battery terminals.
• Clean battery terminals.
• Loose or damaged wiring.
• Check all wiring.
• Faulty ignition switch.
• Check/replace ignition
switch.
• Faulty solenoid or starter.
• Check/replace solenoid or
starter.
• Faulty operator presence
switch(es).
• Contact an authorized
service center/department.
28