Craftsman 917.249392 - Manual (Page 14)

FIGURE 14
TOP
COVER A
YOUR SPRING LOADED MOWER DEFLEC­
TOR SHIELD !FIG. 141 MUST NOT BE
REMOVED SIMPLY ROTATE IT UP AND
HOLD IN UP POSITION WHILE AT­
TACHING CHUTE EXTENSION. THE
MOWER DEFLECTOR SHIELD CAN BE
RELEASED TO REST AGAINST CHUTE EX­
TENSION. THIS WILL ASSURE DEFLEC­
TOR SHIELD IS STILL ON MOWER IF
CHUTE EXTENSION OF GRASS CATCHER
ATTACHMENT IS REMOVED.
13
FIGURE 15
ELBOW
SHIELD
Assemble chute extension to mower housing.
3. Remove cardboard insert from rectangular
opening.
b. Insert chute extension pin into latch assembly
spacer (Fig. 14 - R.H. Inset}.
c. Lift up slightly on L.H side of chute extension
lining up spacers located on latch assembly and
chute extension (Fig 14
- Lower Inset}.
d. Secure R.H, side of chute extension to latch
assembly using: retainer spring (shown full size
below} (Fig. 14 - R.H Inset} Chute extension
and retainer spring furnished with grass
' catcher.
14