H* ®(o) – Craftsman 917.249392 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SUPPORT POST
ASSEMBLY

RETAINER
SPRING

REAR
MOUNTING

BRACKET

SUPPORT
BRACKET
PIN

FIGURE 10

Assemble the support post assembly to the rear
mounting bracket IFig 10) using support bracket
pin and retainer spring Retainer spring shown full

size below. Support past, latch pin and retainer

spring furnisheid with bagger

Install end plug {Fig. 11) on elbow support tube. End

plug furnished with bagger.

Mount the elbow retainer and the elbow shield to

the elbow support tube (Fig. 11) using: two form

ed washers and two 5/16 locknuts (shown full size
below). NOTE: Do not tighten. Elbow retainer,
elbow shield and hardware furnished with bagger:

ELBOW

RETAINER

FORMED WASHERS

SUPPORT POST
ASSEMBLY

END PLUG

ELBOW

SUPPORT
TUBE

ELBOW SHIELD

Locate the hole in one end of the elbow. Slide this
end of the elbow through elbow retainer (Fig. 12

Inset). Secure elbow to elbow retainer usirig: one
clip, one sere-,., two washers and one acorn nut
NOTE: Mount clip in hole located 2 - 1/2” from edge
of elbow Hardware shown full size below. Head of
screw and flat washer mount to the inside of elbow.
Position clip with closed end of clip facing tube open

ing as shown in Fig 12

Inset Tighten securely.

NOTE: Tighten hardware assembled in step 7. Elbow
and hardware furnished with grass catcher

H* ®(o)

9. Flip seat forward.

FIGURE 11

LOCKNUTS