Craftsman 917.249392 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

0. Place L.H. baffle (Fig. 4) on lip of mower housing.

Secure

L .H, runner to L.H. baffle and mower hous

ing using: two 5/16 carriage bolts and two 5/16
locknuts (shown full size below) NOTE: Do not

tighten. L.H baffle and hardware furnished with

bagger.

1 1 Using a 1/2" wrench remove hardware "D" (Fig.

5 - Inset) securing discharge guard to mower hous

ing. Hardware may be discarded.

1 2. Using a 1/2” wrench remove hardware "A", "8"

and

"C"

(Fig. 6) securing R.H. runner to mower

housing. Hardware may be discarded.
Place R.H. baffle (Fig. 4) on lip of mower housing.
Secure R.H. runner to R.H. baffle and mower hous
ing using: one 5/16 carriage bolt and one 5/16
locknut (shown full size below) NOTE: Do not
tighten. R.H. baffle and hardware furnished with

grass catcher.

14. Secure L.H. baffle and R.H. baffle to mower hous

ing using: four clamps, four 1/4 hex bolts and four

1/4 locknuts (shown full size below). Clamps and

hardware furnished with grass catcher.

a. Place clamps (Fig. 7) over holes in L.H. and R.H.

baffles (Fig. 7). Bolt heads to underside of
mower

housing.

Tighten

securely.

NOTE:

Tighten

hardware

assembled

step

securely.

Assemble latch assembly to top of R.H. runner (Fig.

8) using: two 5/16 carriage bolts and two 5/16

locknuts (shown full size below). Bolt heads to
underside of mower housing. NOTE: Do not tighten.
Latch assembly and hardware furnished with grass
catcher.