Sony STR-DE345 - Manual (Page 20)

Additional Information
Specifications
Audio power specifications
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION
With 8-ohm load, both
channels driven, from 20 -
20,000 Hz, rated 100 watts
per channel minimum RMS
power, with no more than
0.09 % total harmonic
distortion from 250
milliwatts to rated output.
Amplifier section
Rated Power
Output at
Stereo Mode
(8 ohms at 20 Hz - 20 kHz,
THD 0.09%)
100 W + 100 W
Reference (8 ohms at 1 kHz, THD
Power Output 0.7%)
Front: 100 W + 100 W
Center: 100 W
Rear: 100 W + 100 W
Frequency
response
Inputs
TV/SAT, CD, MD/
TAPE, VIDEO, 5.1 CH/
DVD:
10 Hz-50 kHz TdB
Sensitivity Impedance S/N
CD,
5.1 CH/
DVD, 50
Mnn-ADc ISOmV ...“"y 85dB
MD/TAPE, ktlohms
TV/SAT,
VIDEO
Outputs MD/TAPE REC OUT:
Voltage: 150 mV,
Impedance: 10 kilohms
VIEIEO AUDIO OUT:
Voltage: 150 mV,
Impedance: 10 kilohms
SUB WOOFER:
Voltage: 2 V
Impedance: 1 kilohms
PHONES: Accepts low
* You can change the AM tuning interval
between 9 kHz and 10 kHz. Turn off the
receiver and press l/Cl) (power) for more
than 4 seconds until "INITIAL" appears.
1) After tuning in any AM station, turn
off the receiver.
2) Hold down PRESET TUNING + button
and press the 1/(1) (power) button.
"9k STEP" appears.
Muting
BASS BOOST
and high impedance
headphones
Full mute
+6 dBat 70 Hz
To change to lOk Step, repeat step 1 and 2
until "10k STEP" appears. Note that all
preset stations, index names and sound field
are cleared after you make the procedure
above.
TONE
Tuner section
±6 clB at 100 Hz and
10 kHz
Video section
Inputs VIDEO, TV/SAT,
5.1CH/DVD:
1 Vp-p 75 ohms
FM stereo, FM/AM superheterodyne tuner
FM tuner section
Outputs VIDEO, MONITOR:
1 Vp-p 75 ohms
Tuning range 87.5 - 108.0 MHz
General
Antenna terminals 75 ohms, unbalanced
Intermediate 10.7 MHz
frequency
Sensitivity Mono 18.3 dBf, 4.5 >/V
Stereo: 38.3 dBf, 45 ¡ i V
Usable sensitivity 11.2 dBf, 2 pV (IHF)
System Tuner section: PLL
quartz-locked digital
synthesizer system
Preamplifier section:
Low-noise NF type
equalizer
Power amplifier section;
Pure-complementary
SEPP
S/N Mono: 76 dB
Stereo: 70 dB Power
requirements
120 V AC, 60 Hz
Harmonic Mono: 0.3 %
distortion at 1 kHz Stereo: 0.5 %
Power
consumption
235W
Separation 45 dB at 1 kHz Dimensions
17x5 ^ / s X 12 inches
(430
X
145
X
304 mm)
Frequency
response
30Hz-15kHzl° dB
Mass (Approx.)
7.3 kg (16 lb 2 oz)
Selectivity 60 dB at 400 kHz
AM tuner section
Tuning range 10 kHz interval*
530- 1710 kHz
9 kHz interval
531 -1710 kHz
Supplied See page 4
accessories
Design and specifications are subject to
change without notice.
Antenna Loop antenna
Intermediate
frequency
450 Idfz
Usable sensitivity 50 dB/m (at 1,000 kHz or
999 kHz)
S/N
54 dB (at 50 mV/m)
Harmonic
distortion
0.5 % (50mV/m,
400 Hz)
Selectivity At 9 kHz: 35 dB
At 10 kHz: 40 dB
20