PulseTech HD-BT12 Bench Top Charger (746X850) - Manual (Page 5)

- 3 -
h) Use charger for charging a LEAD-ACID battery only. It is not
intended to supply power to a low voltage electrical system other
than in a starter-motor application. Do not use battery charger for
charging dry-cell batteries that are commonly used with home
appliances. These batteries may burst and cause injury to persons
and damage to property.
i) NEVER charge a frozen battery.
j) CAUTION: Pinch/Crush Hazard. Close lid slowly. Ensure battery
cables are properly routed through the front.
11. PREPARING TO CHARGE
a) Remove battery from vehicle to charge. Always remove grounded
terminal from battery first. Make sure all accessories in the vehicle
are off, so as not to cause an arc.
b) Be sure area around battery is well ventilated while battery is
being charged. Gas can be forcefully blown away by using a piece of
cardboard or other nonmetallic material as a fan.
c) Clean battery terminals. Be careful to keep corrosion from
coming in contact with eyes.
d) Add distilled water in each cell until battery acid reaches level
specified by battery manufacturer. This helps purge excessive gas
from cells. Do not overfill. For a battery without cell caps, carefully
follow manufacturer’s recharging instructions.
e) Study all battery manufacturer’s specific precautions such as
removing or not removing cell caps while charging and recommended
rates of charge.
f) Determine voltage of battery and make sure it matches the output
rating of the battery charger.
12. CHARGER LOCATION
a) Locate charger as far away from battery as dc cables permit.