BE Pressure supply 2500 Watt Inverters Generators - Manual (Page 19)

19
operation
• When an electric motor is started, both the overload indicator light (red)
and the output indicator light (green) may go on simultaneously. This
is normal if the overload indicator light (red) goes off after about four
seconds.
• If the overload indicator light (red) stays on, consult your dealer.
1. Connect the ground terminal
WARNINg
• Before connecting an appliance to the generator,
check that it is in good order, and that its electrical
rating does not exceed that of the generator. Then
connect the power cord of the appliance, and start the
engine.
• Be sure all equipment is turned off before plugging in
the power cord.
Output and Overload Indicators.
• The output indicator light (green) will remain lighted during normal
operating conditions.
• If the generator is overloaded or of here is a short in the connected
appliance, the output indicator light (green) will go OFF, the overload
indicator light (red) will go ON and current to the connected appliance
will be shut off.
• Stop the engine if the overload indicator light (red) switches ON and
investigate the overload source.
Grounding
Terminal
**I2500 Image
**I2500 Image
Output Indicator Light
Overload Indicator Light
Oil Alarm Indicator
I2500_3500 Inverter Generator Manual_2011.indd 19 18/10/2011 2:03:50 PM