Great Plains Swath Command Section Control - Manual (Page 29)

Great Plains Manufacturing, Inc. Table of Contents Index Install Harness 25
2012-08-23 Table of Contents Index 402-382M
Connect Valve Blocks
Connect 1st Valve Block
151. Connect the 6-pin weatherpak connector marked for
outputs 1-4 to the first solenoid valve .
Connect 2nd Valve Block (if any)
152. Move to the next (second) valve. If the valve lead
cannot reach the WSMB to which it is assigned,
select one of:
823-336C EXTENSION HARNESS 25’6 PIN WP
823-337C EXTENSION HARNESS 40’6 PIN WP
Per the layout, connect the second valve to
WSMB#1 outputs 5-8, or to WSMB#2 outputs 1-4.
Use the extension as needed to make the
connection.
Cable Damage Risk:
If an extension is used, and crosses a wing pivot, route it with
the existing seed hoses, harnesses and air tubing.
Connect 3rd Valve Block (if any)
153. Connect the valve lead to the Output 1-4 lead of the
second WSMB.
Secure Tubing and Harnesses
Use cable ties to secure all tubing and harnesses.
Do not install ties in the bend radius at wing pivots.
272
264
265