Great Plains Series II Native Grass Agitator - Manual

Great Plains Mfg., Inc.
Installation Instructions 1
©Copyright 2006 Printed 04/11/2007 202-599M
Series II Native Grass Agitator
Native Grass Drills
Used with:
• Pre-2007 605NT, 3P605NT
• Pre-2007 706, 1006 Native Grass
• Pre-2007 3PNG12, 3PNG15, 2SNG24, 2SNG30, NG12 Grass Seeder
General Information
These instructions explain how to install a Series II Native
Grass Agitator. These kits enhance your Great Plains
Native Grass Drill for more consistent and efficient seeding
of native grass. Kits are supplied for most Great Plains
Native Grass Drills. If your drill is not listed above, have your
dealer contact the factory, as a kit may be available.
This update is only for drills with
3 ⁄
4
in hexagonal agitator
shafts in the seed box. If your drill does not have a
3 ⁄
4
hex
shaft, a shaft update kit may be available.
If your drill is a Series II, you already have this enhance-
ment.
These instructions apply to:
For a complete Series II enhancement, separately order
multiple feeder sprocket kits below:
Before You Start
Each kit converts an entire drill. You need the correct kit
for your machine.
Due to interference with partitions, it may not be possible
to install divider agitators at all dividers. Due to partition
re-alignments over various model years, you may have
divider agitators left over after the upgrade.
.Have the following tools at hand:
• Basic hand tools
• Updated Parts Manual
• Drill Operator’s Manual
Notations and Conventions
“Left” and “Right” are facing in the direction of machine
travel.
202-600A 6’ NG SERIES II AGITATOR KIT
202-601A 706-7 1/2” NG SERIES II AGT.
202-602A 1006-7 1/2” NG SERIES II AGT.
202-603A NG-12 SERIES II AGITATOR
202-604A 12’ 7 1/2” NG SERIES II AGT.
202-605A 12’ 10” NG SERIES II AGT.
202-606A 15’ 7 1/2” NG SERIES II AGT.
202-607A 15’ 10” NG SERIES II AGT.
Figure 1
Series II Agitator
25124
L
R
FRONT
BACK
202-597A NG CUP ENHANCEMENT KIT
(order one of these kits per row)
callouts identify components in the currently
referenced Figure or Figures.
to callouts reference new parts from the list on
page 8. The descriptions match those on the
cartons, bags or item tags, as well as your
updated Parts Manual.
to callouts reference existing parts. The descrip-
tions match those in your Parts Manual.
1
11 26
51 55