Rear panel 1 1 2 3 – K-array KP102 User Manual
Page 11
REV. A
KP52/KP102
11
8. REAR PANEL
1
1
2
3
1)
Mounting screw holes. Most K-array mounting or flying accessories are designed to screw into the speakers
using these holes. The KP52 is equipped with two screw holes, while the KP102 is equipped with four.
2)
Impedance switch. Selects the impedance of the speaker. Impedance must be set to high (32 Ω for KK52
and 16 Ω for KK102) when speakers are driven by KMT active modules. Low impedance may be used when
speakers are driven by most KA series amplifiers (KA3, KA7, KA10). Please refer to your amplifier’s specifications
to select the correct speaker impedance for your configuration.
3)
Coverage switch. Selects the vertical dispersion of the speaker. Flood coverage sets a wide vertical
diffusion angle of 60° (KP52) / 35° (KP102). Flood coverage is suggested for single speakers in diffused
(image
1)
short throw applications, to obtain maximum diffusion with a minimum footprint. Spot coverage sets a narrower
vertical diffusion angle of 10° (KP52) / 7° (KP102). Spot coverage is recommended for long throw or monitoring
applications
(image 2)
. In most multi-speaker applications, set coverage to Spot
(image 3)
A combination of
Flood and Spot may also be effective for downfill applications
(image 4)
.