beautypg.com

Glyph DVD Duper1 User Manual

Page 49

background image

45

AEC-7763LC/LD & ARS-2022/2022D

You can get the newest firmware version from ACARD by e-mail, or download it

directly from the web site: http://www.acard.com Then, unzip the file “cdxxx.bin”

and copy it into a blank DVD.

After placing the DVD on the DVD-ROM, press ENT. The system will begin searching

the new firmware and show the message on LCD as follows after it finds the new

firmware. Then press ENT to update.

Press ESC, ENT,

to select Erase & Copy as the following figure shows. Erase &

Copy is to erase and write repeatedly. It is only for DVD rewriteable disk.

Press ENT and use

▲ ▼

to select the time of simulation such as 1, 2, 3...1000 or

Run Continuous. The figure below shows Run Continuous.

5.12.7 Update Firmware

On the above figure press ESC and

to enter the following figure. Update Firmware

is to update firmware to the latest version. But you should get the version first.

12-07. Adv Setup

Update Firmware

Burn-in

Erase&Copy

Sel burn-in num:

Run Continuous

Searching F/W---

XXX/XXXXX