Glyph DVD Duper1 User Manual
Page 48

44
AEC-7763LC/LD & ARS-2022/2022D
Press ENT to enter the next figure. Use
▲ ▼
to confirm Disk or Parti.
Press ENT to verify. After verification LCD will show the results as follows.
5.12.6 Burn-in
On the above figure press ESC and
▼
to enter the following figure. Burn-in is to
simulate the copying progress many times. The time can be from 1 to 1000. After
each cycle of simulation, the DVD on the DVD writer will eject automatically and
recede for the next bout of simulation.
Press ENT to enter the next figure. Test is simply a simulation.
Verify Disk or
Partition? Disk
Verify Hard Disk
OK!
12-06. Adv Setup
Burn-in
Burn-in
Test
Press ENT and use
▲ ▼
to select the time of simulation such as 1, 2, 3...1000 or
Run Continuous. The figure below shows Run Continuous.
Sel burn-in num:
Run Continuous