Brinno TLC100 - Manual (Page 11)

1. Insert your USB Flash Drive into any
available USB port on your computer.
Windows will automatically assign a drive
letter to the USB flash drive. Make a note
of the drive letter assigned to the USB
flash drive.
2. Start the “TimeLapse Camera Setup”
program by double clicking the
“TimeLapse Camera Setup” icon in the
“Brinno TimeLapse Camera Setup”
program group. If the program group is
not open, you can open it by using the
“Start, Programs..Brinno” menus to find the
program group.
3. The “TimeLapse Camera Setup” program
has a number of fields that can be
modified. There are two fields that allow
the time and date to be set, and there are
three fields that allow the Custom time
interval to be set. A sixth field is used to
tell the program which drive is to be used
to store the file with the time and date and
custom time interval data. Make sure the
drive letter in this field matches the drive
letter in step 1. Once all the fields have
been set, hit the OK button to save the file.
Loading your Time and Date Stamp and Custom Time
Interval Setting onto your USB Flash Drive
4. Remove the USB flash drive from your
computer’s USB port. Make sure your
TimeLapse Camera is turned off, and
then insert the USB flash drive into your
TimeLapse Camera in between the four AA
batteries.
5. Turn on TimeLapse Camera. When it
detects the time and date file on the
USB flash drive it will automatically load
the data from the file, beep three times,
then turn off. The next time you turn on
TimeLapse Camera it will be set to the time
and date that were in the file. TimeLapse
Camera will also remember the Custom
interval setting that was in the file.
Once you have set up your TimeLapse
Cam you are READY to begin capturing
nature in action everywhere!
9 -
Brinno TimeLapse Camera