Autocue MSP12 Master Series Prompter - Manual (Page 21)

www.qtv.com 17 www.autocue.com
Issue
#
: 081
016
©
2003
-200
8
Au
to
cu
e Grou
p Ltd
Section 5: MSP12 Connections
Physical characteristics
Video and power inputs
MSP12
Assembly and Installation
Guide
5.1.1: Video and power inputs
Connect video cables and power leads to the sockets on the side of the .prompter
display unit.
Power.
Use either a standard mains electrical supply cable to the Mains Input
socket or use the supplied 12 V DC XLR connector to the DC Input socket.
Video. You can connect a video signal via the Video In BNC or use the
prompter display unit directly from your computer using a standard VGA cable.
5.1.2: Autocue cue light
When an on-camera unit is used, the hood can sometimes obscure the cue light on
the camera. To overcome this, Autocue has developed an extension light that is
attached to the hood.
1. Attach the sensor to the light on the camera.
2. Plug the sensor into the Sensor socket on the prompter display unit.
3. Attach the cue light to the top of the hood.
4. Insert the plug from the light in to the CueLight socket.
5. The Autocue cue will illuminate whenever your camera is “live”.