3D Robotics 3DR DIY Quad - Manual (Page 5)

5
1 Motor
assembly
Follow these instructions to assemble
one motor.
1 Attach motor to arm
Place a motor plate on top of the arm
with the short end of the plate facing
towards the end of the arm. Place the
motor on top of the plate, and align
the two small holes in the motor,
plate, and arm. Orient the motor with
the cables as close as possible to the
hole in the side of the arm.
Apply threadlocker to two 5 mm
bolts, and secure the motor and plate
to the arm from below by accessing
through the two large holes in the
bottom of the arm. When applying
threadlocker, use less than one drop,
and cover only four or five threads
where the bolt connects with the
motor. Make sure to insert the bolts
into the holes in the bottom of the
motor and not into the slots where
they could interfere with the motor.