3D Robotics 3DR DIY Quad User Manual
Page 19
19
Place the assembled plates over the
exposed bolts in the top plate, with
the arrows facing towards the blue
arms, and secure with metal nuts.
9 Mount remaining components
Select a location on the copter to
mount the I2C splitter, telemetry
radio, and RC receiver. Use dual lock
or double-sided foam tape to mount
the components. Check that all
components are connected securely
to Pixhawk.
Where you place the components on
the copter is ultimately limited by
the length of the cables between
modules. Experiment with the
different length cables provided with
your kit, and find the best place for
each module on your copter.
(mast not pictured)
top plate
metal nuts
Pixhawk plate