Tenoning jig, Build-it system jig plans – INCRA Miter Slider User Manual
Page 8
A
tenoning jig can be an extremely valuable tool at the table saw. Not only does it provide a carrier for narrow pieces when
tenoning, but with the vertical backstop removed, the jig can also be used for raised panel cutting. The sliding base provides
plenty of range of motion for positioning and locating your cuts, while the large 10” x 10” faceplate provides ample support
and clamping area for the largest of panels.
Begin by adding a Miter Slider to a small Build-It Panel. Place in your table saw’s miter slot and adjust for a good fit. If the
blade tilts right, place it in the left hand miter slot. If the blade tilts left, place it in the right hand miter slot. Add a T-Slot
Panel Connector to each edge of the panel. Cut the slotted holes and grooves as shown on the (2) 10” x 10” x 3/4” thick panels.
If you are using MDF, you can cut the
grooves with a 3/4” straight bit at your
router table. If you are using plywood,
remember it is
often slightly
undersized so an
undersized
“plywood bit” is
recommended
for the cuts. The
depth of cut
should be 1/4”
and the fence to
bit distance is 5/8” for all of the grooves.
Before gluing up the panels and braces,
drill the (2) 5/16” dia. holes in the
faceplate panel. Make the (2) edge
guides as shown. Attach the first edge
guide to the Build-It Platform and
square it to the edge of the platform.
Slide the right angle assembly up against
the edge guide, then add the other
edge guide. Drill and attach the
backstop to finish.
©2007 by Taylor Design Group. All rights reserved. Rev.08.17.07
build-it system jig plans
Tenoning Jig
Fig.1
Fig.2
Build-It Platform Components Required:
• 1 Small Build-It Panel • 1 Miter Slider
• 2 T-Slot Panel Connectors
• Build-It Knobs
Just add:
Fig.3
Detail 3A
braces
(
3
/
4
” stock)
6”
6”
3”
1
1
/
2
”
1
/
4
-20 x 2”
hex bolt
12”
4”
4”
4”
4”
faceplate
1
/
4
-20 x 1
1
/
2
” (6)
hex bolt
11
1
/
2
”
8
1
/
2
”
1
1
/
2
”
1
3
/
4
”
7
/
8
”
10”
8”
1”
Edge guide (
3
/
4
” stock)
(note: all holes
5
/
16
” dia.)
5/8
”
5/8
”
5/8
”
all grooves
(
3
/
4
” wide x
1
/
4
” deep)
8”
long x
5
/
16
” wide
slots
backstop
(
3
/
4
” stock)
10”
2
1
/
2
”
2
1
/
2
”
INCRA MITER SLIDER OWNER’S MANUAL & JIG PLANS
Page 8
Manufactured by: Taylor Design Group, Inc. P.O. BOX. 810262 Dallas, TX 75381
W W W . I N C R A . C O M
Plan #
006