INCRA Bend Rule - Manual

12" Precision Bend Rule
Put YOUR Mark on Precision
When accuracy counts …
INCRA RULES!
Manufactured by:
Taylor Design Group
P.O. Box 810262
Dallas, Texas 75381
www.incra.com
INCRA is a Registered
Trademark of Taylor
Design Group, Inc.
©2013 Taylor Design Group, Inc.
INCRA RULES are available in many other
popular styles and lengths.
7
5 1 9 2 2 5 0 6 0 2
5
Precision Bend Rule
Easy and Accurate
To mark with a 0.5mm Mechanical
Pencil: Just hold the pencil vertically and
draw a short line in one of the slots, or
twist the pencil in a hole to mark a dot.
To mark with a Wooden Pencil: First,
sharpen the pencil, then twist the lead once
or twice in any one of the holes to give it an
ultra fine point ready for marking.
To mark with a Metal Scribe or Center
Punch: Any scribe or center punch sharp
enough to fit through the holes can be
used. Use finger pressure ONLY to mark a
precisely located “dimple” in soft materials
such as wood, paper, plastic, brass or alu-
minum. DO NOT damage your precision
rule by pounding the point through the
hole with a hammer.
Any rule can just
measure, but only
INCRA guarantees
YOUR mark of
precision on
everything you do!
6" Precision Bend Rule
FIG. i.eps
6" Precision Bend Rule
Fig G.eps
Using the vertical scale:
Use the holes in the vertical scale to draw
your mark parallel to the edge.
Marking:
Place your mark in the hole or slot at the
desired measurement.
Measuring:
Place the scale as shown for easy viewing
and precise measurements.