InnoMax Scape Adjustable Power Base - Manual (Page 8)

PowerBASE Owners Manual
INSTALLATION
6. Remove the plastic packaging from the
bed base frame. Carefully rotate the base
frame over to position the bed top-side-up.
7. Plug power cord into a working, grounded
electrical outlet. Note: an electrical surge
protection device is recommended (not
included).
8. If hand control is non-wired type, Install
batteries in hand control (wired hand
controls do not require batteries). Briefly
activate all functions of the bed with the
hand control to verify all features are in
working order. If bed does not operate,
refer to the Troubleshooting section of this
manual.
9. Return bed to the level position.
2. Carefully Lift the bed base frame from the
shipping carton, keeping the unit top-side-
down.
3. Install (4) legs into the base frame. Simply
screw each leg into a tapped hole at each
corner of the base frame (FIGURE 1). Insert
casters into the bottom of each bed leg (if
applicable).
4. Remove and extend out power cord from
the protective packaging.
5. For beds equipped with power down box,
install (2) 9 volt batteries into the power
down box (FIGURES 2 and 3).
Note: beds
not equipped with power down box do
not require batteries.
FIGURE 1: PowerBASE™ leg installation. Caster installation (if
applicable).
LEGS – SCREW INTO
TAPPED HOLE AT
EACH CORNER
CASTERS – PRESS-FIT
INTO BOTTOM OF
LEGS (IF APPLICABLE)
POWER CORDS MUST NOT INTERFERE
WITH ANY ADJUSTABLE BED
MECHANISMS.
FIGURE 2: Power down box battery compartment door
removal.
PRESS IN (SLIGHTLY) AND
PUSH DOWN TO REMOVE
BATTERY COMPARTMENT
DOOR
POWER DOWN BOX
BATTERY COMPARTMENT DOOR
BATTERY ORIENTATION IS
INDICATED INSIDE BATTERY
COMPARTMENT
DOOR REINSTALLATION:
PRESS COMPARTMENT DOOR
AGAINST THE BATTERY ENDS,
SLIDE DOOR UP AND IN
TO ENGAGE THE DOOR TABS
TABS
FIGURE 3: Power down box battery installation and battery
compartment door reinstallation.
6