InnoMax Scape Adjustable Power Base - Manual (Page 10)

PowerBASE Owners Manual
INSTALLATION
12. Install headboard bracket assemblies per
the following procedure:
a. Raise the head section of the bed (with
hand control) to gain access to the bed
base frame.
b. Slide one headboard bracket channel
onto one side of the bed base frame.
Using (2) bolts/nuts (
FIGURE 8) attach
channel to base frame ( FIGURE 9).
Hand tighten bolts/nuts (loosely) to
allow adjustment of the headboard
bracket channels. Repeat procedure to
install the other headboard bracket
channel to the other side.
3 inches MAX
.
FIGURE 7: headboard cross member location must not
exceed 3 inches (76.2mm) from the top of the mattress.
FIGURE 8: Headboard bracket hardware (not included with
Pro-Motion™ and Profile products).
HEADBOARD BRACKET
HARDWARE KIT CONTAINS:
(4) 3 INCH CARRIAGE BOLTS - A
(4) 1 INCH HEX HEAD BOLTS - B
(8) NUTS - C
C
A
B
c. Attach one headboard bracket flange
to one of the bracket channels with (2)
bolts/nuts. (
FIGURE 10) Tighten bolts.
Repeat procedure to attach the other
headboard bracket flange.
FIGURE 9: Headboard bracket channel installation (one each
side of the head section of the bed).
SLIDE HEADBOARD
BRACKET CHANNEL OVER
THE BED BASE FRAME
EXTENSION
USE (2) 3 INCH CARRIAGE BOLTS AND
NUTS TO ATTACH EACH BRACKET
CHANNEL TO BED BASE FRAME
EXTENSION
ANGLE
BRACE
QUEEN SIZE HEADBOARD BRACKET
ASSEMBLIES ARE SHOWN. TWIN SIZE
HEADBOARD BRACKETS (OR SMALLER)
ARE NOT EQUIPPED WITH ANGLE BRACE
(FIGURES 9 and 10).
NOTE
FIGURE 10: Headboard bracket flange installation (attach one
flange to each of the headboard bracket channels).
USE (2) 1 INCH BOLTS AND
NUTS (TIGHTEN) TO ATTACH
HEADBOARD BRACKET FLANGE
TO EACH BRACKET CHANNEL
ANGLE
BRACE
8