Sharp MX-M232D - Manual (Page 81)

79
PROGRAMMING
6
[PROGRAMMING AN F-CODE CONFIDENTIAL BOX]
Follow the steps below to program an F-code
confidential reception box. An F-code (sub-address
and passcode) for F-code confidential reception and a
print passcode to print out received faxes are
programmed in each box. Up to 10 boxes can be
programmed. To check the contents of a programmed
box, print the following list: "PRINT - REPORT - SUB
ADD SET LIST". (Page 85)
To program an F-code confidential box, follow steps 1
through 6 on page 78 and then follow the steps below.
7 Select an unused box ("- - - - - -") with
the [
] or [ ] key.
8 Press the [OK] key.
9 Enter a name for the F-code
confidential box (see "ENTERING
CHARACTERS" on page 86).
Up to 36 characters can be entered for the name. A
box name must be entered.
10 Press the [OK] key.
11 Enter a sub-address (maximum 20
digits) with the numeric keys.
See steps 3 and 4 on page 69.
12 Enter a passcode (maximum 20 digits)
with the numeric keys.
See steps 5 and 6 on page 69.
13 Enter the print passcode (4 digits)
with the numeric keys.
The characters " " and "#" cannot be used. The print
passcode cannot be omitted. Take care not to forget
the programmed print passcode. If you forget the
passcode, consult your Sharp dealer.
14 Press the [OK] key.
PQ
ACC
LEX SCAN
LEX SCAN
DED COPY
S.A. CONF. BOX
SBC CO.
— — — — — —
— — — — — —
[OK]:STORE START
GHI
PQRS
BACK OK
46 47 48 49 50
41 42 43 44 45
36 37 38 39 40
31 32 33 34 35
26 27 28 29 30
A B C D E
F G H I J
K L M N O
P Q R S T
U V W XYZ SP
S.A.CONF.BX NAME
ABC
OK
ABC DEF
JKL GHI MNO
TUV PQRS WXYZ
@.-_
READ-END ACC. #-C
OK
ENTER CONF. CODE
_ ___
(0000-9999)
OK