AEG HC412000GB - Manual (Page 29)

min.
30 mm
min. 20 mm
• Seal the gap between the worktop
and glass ceramic with silicone.
• Put some soapy water on the silicone.
• Pull off the excess silicone with the
scraper.
8.7 The installation of more
than one appliance
Added parts:connection bar(s), heat re-
sistant silicon, rubber shape, sealing
strap.
Only use special a heat - resistant
silicon.
The worktop cut out
Distance from the wall : minimum 50 mm
Depth : 490 mm
Width : sum widths of all the appliances
to be built-in and subtract 20 mm (see
also "Overview of all appliance widths" )
Example :
580 mm
520 mm 490 mm
360 mm
+ - =
20 mm 920 mm
The installation of more than one appli-
ance
1. Put down the dimension of the work-
top cut out and saw it out.
2. Put the appliances one at time on
some soft surface, a blanket for ex-
ample, with the bottom side up.
3. Put the seal stripe around the lower
edge of the appliance along the out-
er edge of the glass ceramic.
4. Loosely screw the fixing plates into
the appropriate holes in the protec-
tive casing.
5. Put the first appliance in the worktop
cut out. Put the connection bar in
the worktop cut out and push up
half of the width against the appli-
ance.
6. Loosely turn in fixing plates from be-
low on the worktop and on the con-
nection bar.
7. Put the subsequent appliance in the
worktop cut out . Make sure that the
ENGLISH
29