AGFA IT SR 24 - Manual (Page 38)

3. Control Panel Keys and Indicators
2-13
Sc
ann
er
Ch
apte
r 2
When (Misfeed/Call-Tech.-Rep. Code) Lights up
This indicates that a paper misfeed or malfunction has occurred in the system. Check the code
shown on the Multi-Print Display and perform the misfeed clearing procedure or the Call
your Technical Department.
Locate the misfeed using the code and perform the misfeed clearing procedure.
Code Description
The Projection Lamp is burned out. Replace the lamp.
☞
See p. 2-32.
* If the lamp goes out during a print cycle, a blank print may
be output.
The power to the printer is off or there is a problem with the
connection of the interface cable to the printer. Turn on the
printer or make sure that the interface cable is securely con-
nected.
The upper cover of the printer is not closed. Make sure that it
is completely closed.
The printer is out of paper. Load some paper into the paper
cassette.
☞
See p. 3-4.
The Scanner is connected to the PC and ready for scanning by
pressing the Start Key. This display is blinking when the Scan-
ner is in operation.
The Scanner is not connected to the PC. Turn ON the PC or
connect the Scanner to the PC with the interface cable.
Code Description
The wrong size paper has been loaded in the Paper Feeding
Tray. Load
A4 (8.5" ×11") . This code also appears when two
or more sheets of paper are taken up at the same time.
A misfeed near the paper take-up section.
A misfeed near the Imaging Cartridge.
A misfeed near the Fusing Unit
Malfunctions Procedure
Misfeed Clearing Procedure
0820771003.book Page 13 Monday, March 19, 2001 2:49 PM