Konica Minolta bizhub 361 - Manual (Page 73)

501/421/361 2-56
Administrator Operations 2
4
Touch [OK].
? What if an Administrator Password different from that is currently registered is mistakenly entered?
% If there is a mismatch between the currently registered Administrator Password and the
Administrator Password entered, a message appears that tells that there is a mismatch in the
Administrator Passwords. Enter the correct Administrator Password.
% If the Enhanced Security Mode is set to [ON], entry of a wrong password is counted as unauthorized
access. If a wrong Administrator Password is entered a predetermined number of times (once to
three times) set by the Administrator of the machine, the Utility screen appears and the machine is
set into an access lock state. To cancel the access lock state, settings must be made by the Service
Engineer; or, turn off, and then turn on, the main power switch of the machine. If the main power
switch is turned off and on, the access lock state is canceled after the lapse of time set for [Release
Time Settings]. When the main power switch is turned off, then on again, wait at least 10 seconds
to turn it on after turning it off. If there is no wait period between turning the main power switch off,
then on again, the machine may not function properly.
Here is the sequence, through which the main power switch and sub power switch are turned on
and off:
Turn off the sub power switch
→ Turn off the main power switch → Turn on the main power switch →
Turn on the sub power switch
5
Enter the new 8-digit Administrator Password from the keyboard and keypad.
– Press the [C] key to clear all characters.
– Touch [Delete] to delete the last character entered.
– Touch [Shift] to show the upper case/symbol screen.
– Touch [Cancel] to go back to the Security Settings screen.
6
Touch [OK].
? What happens if the Administrator Password entered does not meet the requirements of the
Password Rules?
% If the Administrator Password entered does not comply with the Password Rules, a message
appears that tells that the Administrator Password entered cannot be used. Enter the correct
Administrator Password. For details of the Password Rules, see
"Password Rules" on page 1-9 .