Kramer Electronics FC-41 - Manual (Page 11)

8 FC-41 - Connecting the FC-41
5 Connecting the FC-41
Always switch off the power to each device before connecting it to your
FC-41. After connecting your FC-41, connect its power and then switch
on the power to each device.
To connect the FC-41, as illustrated in the example in Figure 3 , do the following:
1. Connect the SDI source (for example, an HD-SDI Video player) to the SDI IN
BNC connector.
2. Connect the OUTPUTS:

Connect the SDI BNC connector to an HD-SDI acceptor (for example,
a non-linear editor)
 Connect the SDI BNC connector to an HD-SDI acceptor (for example,
an HD-SDI display)
 Connect the Y, PB, PR BNC connectors to a component video
acceptor (for example, a plasma display)
 Connect the RGB/HV 15-pin HD computer graphics video connector to
an RGBHV acceptor (for example, a projector)
3. Connect a PC or other controller, if required (see Section ‎5.1 ).
4. Connect the power cord (not shown in Figure 3 ).
i