Kramer Electronics RC-43T - Manual (Page 16)

RC-43T - Installing the RC-43T 13
6 Installing the RC-43T
Installing the RC-43T consists of the following steps:

Installing the required buttons (see Section
6.1
)

Connecting the RC-43T to the room controller or other auxiliary devices (see
Section 5.1 )

Programming the room controller for the RC-43T
Note: Programming is covered by the K-Config User Manual and therefore
not described here.

Installing the RC-43T in the wall mounting box (see Section
6.2
)
6.1 Installing the Front Panel Buttons
The RC-43T is supplied with preprinted buttons from which you can choose the six
that best represent the functions you wish to assign the buttons.
To install the front panel buttons:
1. Remove the front panel (see Figure 2 and Figure 3 ) by carefully prying it
away from the PC Board frame using a small screwdriver being careful not to
damage it.
2. Remove the stock buttons from the front panel.
3. Remove the six required buttons from the plastic tree.
4. Insert the buttons into the front panel taking care to insure that they are
oriented correctly.
5. Place the PC Board and frame onto the front panel insuring that the
mounting orientation tongue is in line with the cutout on the front panel.
6. Press the front panel and PC Board frame together securely.