Kramer Electronics RC-43T - Manual (Page 12)

RC-43T - Defining the RC-43T Remote Controller 9
Figure 5: RC-43T Remote Controller Rear View EU Version
# Feature Description
1 Mounting Holes Attach the RC-43T to the wall mounting box
with the screws provided (see
Section 6.2 )
2 SW7 K-NET
Termination Switch Use to set the K-NET bus termination (see
Section 5.2 )
3 KNET 4-pin Captive-
screw Terminal Block Connect to a master room controller or to
another auxiliary device (see
Section 5.1 ).
Note: The RC-43T is always device ID 2 on
the K-NET bus. This cannot be changed
4 PC Board
5 PC Board Frame Mounting panel that houses the PC Board
6 Front Panel Cosmetic panel that covers the PC Board and
houses the removable buttons
7 PC Board Frame
Alignment Tongue Align this tongue with the cutout in the front
panel when mounting the PC Board frame to
the front panel