AZEK Rail - Manual (Page 2)

Page 2
Installing AZEK Rail with Glass Infill
2.73”
2.05”
Trademark
Bottom Rail
3.5”
2.64”
Trademark
Top Rail
5.38”
2.72”
Reserve Top
Rail
3.5”
2.05”
Reserve
Bottom Rail
3.5”
2.63”
Premier Top
Rail
2.72”
2.05”
Premier
Bottom Rail
5.5”
5 1/2” x 5 1/2” Post Sleeve
5.5”
6” x 6” Post Sleeve
6.23”
• AZEK Rail 6’ Rails are designed not to exceed 6’ center
of post to center of post.
• Cut slowly, using a fine tooth saw blade to avoid
chipping.
• For 42” railing use 54” Post Sleeves.
Measuring Your Railing Area
Important Information
Component Dimensions
AZEK Rail with Glass Infill is available in 6’ lengths.
• Measurements are from center to center of post. Rails
are produced in 6’ lengths to allow for finished end
cuts and angles.
• Determine how many 6’ AZEK Custom Rail Packs
you need and check to be sure you have all the
components (and quantities) listed in the chart shown
to the right.
Components Needed For Installing
The AZEK Rail Section
Components available
separately for
mix-and-match rail
systems
Additional
Components
Needed for Each
System
1 - Top Rail
1 - Bottom Rail
2 - Support Rails
Hardware Mounting Kit
Support Block Mounting Templates
1 - Foot Block
AZEK Custom Rail Pack
2 - Post Caps
2 - Post Sleeves
2 - Post Skirts
1/4" Tempered Glass must be
sourced locally (See attached
reference sheet).
• Miter Saw
• Drill
• Measuring Tape Tools Required • 7/64” Drill Bit
• 3/16” Drill Bit
Post Cap (2)
Top Rail (1)
Mounting Bracket (4)
Support Rail (2)
Top Glass
Channel
Bottom Glass
Channel
Rubber
Gasket (2)
Glass Panel
(not included)
Support Block (2)
Bottom Rail
Post Sleeve (2)
Post Skirt (2)
Foot Block
(1 in 6’ Section)
1.8”
1.2” 1.2”
1.8”
.925” .925”
Support Rail
Bottom Glass
Channel
Top Glass
Channel
Rubber
Gasket
4 - Mounting Brackets
2 - Support Blocks
16 - #8 x 3/4” Screws
6 - #8 x 1 3/4” Screws
6 - #8 x 2 5/8” Screws (Stairs Only)
6 - #8 x 3” Screws
12 - #8 x 3” Green Screws
T20 Driver Bit
1 - Top Glass Channel
1 - Bottom Glass Channel
2 - Rubber Gaskets
6 - #8 x 2 1/4” Screws
6 - #8 x 3” Screws
3 - #8 x 1” Screws
Hardware included in
Hardware Kits:
Glass Hardware Pack
Visit www.azek.com/installation to view AZEK installation videos.
Consult your local building codes for guard and handrail
requirements.
6.23”