Power Soak 36212 PS-275 Owner's Manual - Manual (Page 23)

19
5. Leave the PS-275 to run. When the deep wash period is complete,
the deep cleaning period will automatically turn the wash action on
and off (cycle time is selected in the program settings).
Note: During the Deep Cleaning Mode, if sanitizer warning light should
illuminate, it will not affect the cleaning operation.
Changing the Wash Solution
The wash solution will need to be drained and refilled every four hours.
The control program will keep track of this time. 15 minutes before the
wash tank timer expires, the blue beacon will begin flashing.
The beacon will flash faster and faster until the timer expires. When the
timer expires, the wash action will stop and the blue beacon will become
solid.
This indicates that it is time for the wash fluid to be changed. The wash
action can be restarted for one minute using the START button to aid in
unloading the wash tank before draining. (This can be repeated five times)
Changing the Sanitizer Solution
In most cases, the sanitizer solution will need to be drained and refilled
typically every two hours or as advised by the chemical provider. In some
situations a chemical provider and local codes allow a different change
interval. When the sanitizer tank is filled a timer is started. 15 Minutes
before the sanitizer tank timer expires, the red beacon will begin flashing.
The beacon will flash faster and faster until the timer expires. When the
timer expires, red beacon will become solid.
If the program does not detect a solution change after a time, the wash
action will stop and the red and blue beacons will flash in an alternating
pattern.
Once this has happened, the wash pump is “locked out” and the only way
to restart the wash action is to drain and refill the sanitizer tank. The “lock
out” is a setting in the program that can be turned off.