Power Soak 36212 PS-275 Owner's Manual - Manual (Page 21)

17
These are some examples of items that are typically deep-cleaned
overnight in the "Night Wash" cycle:
• Hood Filters
• Roasting Pans
• Stove Tops
• Frying Equipment
• Stock pots
• Carbonized items
• Soiled storage racks
Many other items in the operation may qualify. Be creative and set up a
regular "Night Wash" program for improved sanitation. Items that have
been cleaned overnight should be removed, rinsed, sanitized (if necessary)
and put away or back in place. Sanitation supervisors should establish
standard operating procedures for items to be cleaned using the Night
Washing feature of the Power Soak.
Deep Cleaning Mode
The Deep Cleaning Mode can only be activated by completely draining the
wash tank below the low level sensor and refilling the wash tank. When
the START button is pressed and held for at least 8 seconds, the wash
pump motor will start when the program enters the Deep Clean Mode. If
the START button is simply pressed and released, the wash pump motor
will start and the machine will enter the “Normal Cleaning” mode that is
used for day time operation. If the normal cleaning is stopped within 30
seconds the machine can be re-started in the Deep Cleaning mode. After
30 seconds of operation, the mode is “locked in” and the tank will have to
be completely drained and refilled to start a different mode of operation.
When the pump motor starts in the Deep Cleaning Mode, the indicator light
on the control panel labeled “Deep Cleaning Mode Active” will illuminate.
(Note: if the START button is held for more than 3 second, but less than 8
seconds, the wash motor will not start. The button must be pressed again
for less than 3 seconds to start the Normal Wash or more than 8 seconds
to start the Deep Clean Mode.)
The Deep Cleaning Mode will elevate the water temperature to 128°F /
53°C which is higher than the normal daytime wash temperature (115°F /
48°C). When the Deep Cleaning Mode is entered, the orange beacon and
the control panel light that is labeled “High Wash Fluid Temperature” will
illuminate to indicate that the cleaning solution temperature is going climb
above the normal wash temperature. When the cleaning solution