Power Soak 36212 PS-275 Owner's Manual - Manual (Page 11)

7
START Button
The START button is green and labeled “Start”.
When pressed and released within 4 seconds it will
start the “Normal Mode” wash action. When
pressed and held for 8 seconds, it will start the
Deep Clean Mode. Pressing the STOP button
within 10 seconds will release the selection and
return to “stand by” mode. An automatic chemical
dispenser will be signaled to add the chemicals
according to the mode that has been started when
the START button is pressed. If a cycle does not
start when the START button is pressed and
released, refer to the trouble shooting section.
(See page 8 for operating instructions)
STOP/IDLE Button
The red STOP/IDLE mode button is used to stop or
“pause” the wash action. The wash action will stop
when pressed. Some programming selections will
automatically resume the wash action after a short
period of time if the wash tank is not drained.
(See page 8 for operating instructions)
UNLOAD/LOAD Button
The UNLOAD/LOAD button is white with green up
and down arrows. It is used to indicate to the
program controller that the machine is receiving
proper attention when using the timed unload/load
wash cycle functions.
(See page 14 for operating instructions)
WASH TANK Light
The blue WASH TANK light is used to indicate
when the wash fluid needs to be changed.
SANITIZER TANK Light
The red SANITIZER TANK is used to indicate
when the sanitizer fluid needs to be either filled or
drained.