ASKO T793C - Manual (Page 20)

The machine will not start
Check
• that the door is properly closed.
• that the main power switch is on.
• that the Delayed Start option has not been
selected. To cancel Delayed Start, press
the Stop button for 3 seconds.
• that the machine is not programmed to
start at a specific time (e.g., 13.30)
• that any plug is connected.
• that the fuses (circuit breakers) in your
house are intact. Flip the dryer breaker off
and then back on to make sure. You can
not always tell from the outside if the circuit
breaker has tripped.
• that the overheating cut-off has not been
triggered (see below).
Overheating cut-off
The overheating cut-off shuts off the tumble
dryer if the temperature is too high, caused
by lint clogging the lint filter, for instance.
• Clean the filter.
• The overheating cut-off will reset automat-
ically once the machine has cooled down.
Drying takes too long
• Check that the lint filter and the condenser
are not blocked. See the "Care and main-
tenance" chapter.
• Prolonged drying times may also be due
to the tumble dryer being located in a room
that is too small and the air in the room
(cooling air) being too hot.
• Make sure that the tumble dryer has ac-
cess to more cold air, by opening doors
and/or windows, for example.
The laundry does not dry, or is too
dry
• The door has been opened while the pro-
gram is running, which disrupts the mois-
ture monitoring function.
Error messages
• If Overflow is shown in the display, the
condenser drain hose could be blocked.
Remove the hose from the drain and check
for obstructions. The hose should be insert-
ed no more than 5 or 6 inches into the wall
drain.
• If "Max Program Time" appears on the
display, the maximum program time has
been reached. Read "Drying takes too
long" in the "Troubleshooting" chapter to
find out what to do.
• If "Clean lint filter" appears on the display,
clean the lint filter.
• If "Clean condenser" appears on the dis-
play. See the "Cleaning the condenser"
section of the "Care and cleaning" chapter
for remedy
• Press the Stop button to close error mes-
sages.
Customer Care Center 20
1-800-898-1879
www.askousa.com
Troubleshooting