Front center disk blade, 8k4950 front center single disk blade -17 – 4-18, Summers mfg. co., inc – Summers 2510 DT User Manual
Page 79
Summers Mfg. Co., Inc.
Front Center Disk Blade (8K4950)
Installation Instructions
Refer to following Photos, Parts Breakdown and Steps when installing the Front Center Disk Blade.
a. Hang Front Center Disk Blade Assembly as shown in Photo A. Use appropriate lifting device, the
assembly weighs 129 LB.
b. Attach C-Shank to rear cross tube with Mounting Flats (8K4935) and hardware provided - do not
tighten.
PHOTO A
c. Slide Center Disk Blade Assembly so inside rear 3/4"
X 10" bolt is 12" from center line of Disk (Photo B).
Securely tighten all hardware.
d. Field test Center Disk Blade. If required, Assembly
can be adjusted side to side by loosening 3/4" X 10 bolts,
reposition and retighten hardware. Depth of the Center
Disk Blade can be adjusted by installing or removing
8K4930 flats.
PHOTO B
FRONT OF MACHINE
SECTION 4 - PARTS
4-17