Summers 2510 DT - Manual (Page 16)

BLADE LAYOUT 3/5/2012 9K1827.iam/
15 1/2"
40"
20"
30"
15 1/2"
40"
20"
30"
30"
30"
16 1/2"
16 1/2"
30"
30"
LEGEND:
5 Blade - Gang Size
8K2652 - Gang PN
(8K4692) - Scraper Tube PN
5 blade
8K2452 (DT)
8K2652 (Diamond)
(8K4692)
6 blade
8K2462S (DT)
8K2662S (Diamond)
(8K4690)
6 blade
8K2460S (DT)
8K2660S (Diamond)
(8K4690)
5 blade
8K2450 (DT)
8K2650 (Diamond)
(8K4692)
10 blade
8K2508 (DT)
8K2708 (Diamond)
(8K4670)
10 blade
8K2506 (DT)
8K2706 (Diamond)
(8K4670)
18 1/2'
Front
X
X
X
X
X = 8K4449 OFFSET
SCRAPER LOCATION
WITH 8K4423 FILLER
SECTION 2 - ASSEMBLY
2-6
ASSEMBLY INSTRUCTION FOR ALL SIZES
MOUNTING WEIGHT PACKAGES
Mount weight packages on outside of wings in location that will not interfere with disk gang or tire travel. Install 1/2 weight packages (6
suitcase weights with mounting angles and hardware) by positioning mounting angles 8-1/2” apart. Secure with 3/4” U-bolts, lockwash-
ers and nuts. Fully tighten hardware on one mounting angle. Hand tighten mounting hardware on second mounting angle, this must
be free to slide. Insert one 1” x 10-1/2” bolt through both mounting angles, turn 1” nut onto this bolt until threads are flush with outside
of nut. Spread mounting angles as much as 1” bolt and nut will allow. Lift suitcase weights (8K9230) into position, slide slotted hole of
weight over 1” bolt. Continue to slide weight past corner of slot until it reaches the end of the slot, at this location the hole without slot
will line up with the second hole in the mounting angles. Repeat procedure with remaining suitcase weights. Insert second
1” x 10- 1/2” bolt through angles and weights. Secure second 1” bolt with lockwasher and nut, fully tighten. When second 1” bolt is
tight, remove the nut from first bolt and add the lockwasher. Fully tighten all remaining nuts.
Caution: Each suitcase weight (8K9230) weighs 70#, use extreme care when handling them.
SAFETY
Install SMV mounting bracket at machine center. Install remaining decals at locations shown on page 1-5. Install Safety Light Kit,
refer to breakdown on page 4-19.
MOUNT REAR COULTER GANG
Follow instructions on Pages 2-13 through 2-18.
MOUNT STANDARD 8 FT. M-104 HARROW SECTION
Attach harrow section to the frame directly behind the rear coulter gang using brackets provided. Position brackets and harrow lift arms
as shown on Page 2-17. When an optional full set of mounted harrows or rolling baskets is used, refer to pages 2-19 through 2-34.
8K4950 - FRONT CENTER SINGLE DISK BLADE
Refer to breakdown on page 4-17 & 4-18.