Innovate Motorsports MTX-D, Boost/Shift Gauge - Manual (Page 5)

- 5 -
Avoid connecting or disconnecting any of the ports labeled IN or OUT while
the unit is powered ON.
3.1 Installing the LM Programmer Software
Put the included CD in your CD-drive on your computer and follow the instructions on screen.
The installer includes LogWorks, LM Programmer, manuals, and other tools.
3.2 Hooking up the MTX Boost/Shift gauge to the computer
1. Power OFF the MTX Boost/Shift gauge
2. Connect the supplied serial cable to the port labeled OUT.
3. There should be nothing connected to the port labeled IN.
4. Power ON the MTX Boost/Shift gauge.
5. Connect the serial cable to your computer. If you are using a serial to USB adapter,
connect the serial cable to the adapter then connect the adapter to the computer.
6. Launch LM Programmer. The LM Programmer application can be launched from Start-
>Programs->LogWorks3->LM Programmer from the Windows task bar.
3.3 Programming the Gauge
Whenever a change is made to the programming of the gauge click the Program button for the
change to take effect. Once the gauge has been programmed the Program button will grey out.
To set the gauge back to the factory settings click the Set To Defaults button and then click the
Program button.