ATEN ACS1208 - Manual (Page 30)

ACS1208 / ACS1216 User Manual
18
Invoking Auto Scan:
To start Auto Scanning, key in the following Hotkey combination:
1. Invoke Hotkey Mode with the [NumLock] + [*] or [NumLock] + [-]
combination
2. Press [A]. After you press A, you automatically exit Hotkey Mode, and
enter Auto Scan Mode.
Š While you are in Auto Scan Mode, you can pause the scanning in order
to keep the focus on a particular computer either by pressing P or with
a Left Click of the mouse. During the time that Auto Scanning is
paused, the Command Line displays: Auto Scan: Paused.
Pausing when you want to keep the focus on a particular computer is
more convenient than Exiting Auto Scan Mode because when you
Resume scanning, you start from where you left off. If, on the other
hand, you Exited and restarted, Scanning would start over from the
very first computer on the installation.
To resume Auto Scanning, press any key or Left Click. Scanning
continues from where it left off.
Š While Auto Scan Mode is in effect, ordinary keyboard and mouse
functions are suspended - only Auto Scan Mode compliant keystrokes
and mouse clicks can be input. You must exit Auto Scan Mode in order
to regain normal control of the console.
3. To exit Auto Scan Mode press [Esc] or [Spacebar]. Auto Scanning stops
when you exit Auto Scan Mode.
acs1208-1216.book Page 18 Friday, April 27, 2007 3:23 PM