Adaptec ASH-1233 - Manual (Page 13)

6
Connecting Your ATA Disk Drives
Connecting Your ATA Disk Drives
The ASH-1233 adapter supports up to four ATA disk drives in a
master/slave configuration. (See Setting Jumpers on ATA Disk Drives
on page 5 for more information.)
Connect each ATA disk drive to the ASH-1233 adapter using the
proper 40-pin IDE cable.
Note: The Adaptec ASH-1233 adapter does not support Cable
Select (CSEL) settings. You must change the jumper settings
to set drives as master or slave.
To connect your ATA disk drives, follow the instructions for your
specific drive configuration:
■ To install an ATA disk drive as the only device on a cable, see
page 7 .
■ To install two ATA disk drives on the same cable, see page 8 .
Connector (to Master) Connector (to Slave) Connector (to Adapter)